Sharp PN-CD701-LCD

ENGLISH
5
E
Preparing the Remote Control Unit
1. Placeyourfingeronthepartmarkedwiththe▲,andthenpullthecoveroff.
2. See the instructions in the compartment and put in the batteries (supplied with the PN-ZR02 (optional)) with their
plus (+) and minus (-) sides oriented correctly.
3. Closethecover.
Supplied Components
If any components are missing, please contact your dealer.
* The remote control unit is supplied with the PN-ZR02 (optional).
(Remote control sensor box is not used.)
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.
About USB Type C extend cable
• ConnecttheUSBTypeCextendcable(supplied)betweentheUSBTypeCcable(supplied)andtheexternaldevice.
When connecting/disconnecting to the external device, plug/unplug the USB Type C extend cable to prevent damage to the
USB Type C cable.
Caution
• TheUSBTypeCcablemayalsoprovidepowertotheconnectedcomputer.
Contact your local electrical contractor before running the supplied cable under carpets, behind walls or over ceiling tiles, as
regulations may vary.
Specifications
Model PN-CD701
Power requirement AC 100 V - 240 V, 4.2 A, 50/60 Hz
Operating temperature
*
41°F to 95°F (5°C to 35°C)
Operating humidity 20% to 80% (no condensation)
Power consumption 370 W
Dimensions (excluding protrusions) inch (mm)
Approx. 63-15/16 (W) x 3-9/16 (D) x 38-7/16 (H) (1623.5 x 90.0 x 976.5)
Weight lbs. (kg)
Approx. 143.3 (65)
* Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP.
In such cases, please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.

Liquid Crystal Display Monitor: 1

Power cord

HDMI cable: 1

USB Type C cable (26.2 feet [8 m]): 1

USB Type C extend cable: 1

CD-ROM: 1

Setup Manual (this manual): 1

Touch pen: 1

USB A to B cable (for touch back): 1

Cable clamp: 1

Camera: 1

Knurled screw (M3): 2

USB A to B cable (for camera): 1

S/PDIF cable: 1

3.5 mm mini jack to USB A cable: 1

IoT sensor hub: 1

Micro USB cable (for IoT sensor hub): 1

Knurled screw (M3): 2

IoT sensor hub screw (M3): 2

IoT sensor hub mounting brackets (L/R):
x1 each