Sharp r-32b(st) - Care and Cleaning; Service Call Check; Specifications

Disconnect the power supply cord before cleaning or leave the door open to inactivate the oven.
CLEAN THE OVEN AT REGULAR INTERVALS - Keep the oven clean and remove any food deposits, or it
could lead to deterioration of the surface. This could adversely affect the life of the appliance and possibly
result in a hazardous situation.
Exterior:
The outside may be cleaned with mild soap and warm water, wipe clean with a damp cloth. Avoid the use of
harsh abrasive cleaners. Keep the ventilation openings free of dust.
Door:
Wipe the door and window on both sides, the door seals and adjacent parts frequently with a damp cloth to
remove any spills or spatters. Do not use abrasive cleaners.
Touch Control Panel:
Wipe the panel with a cloth dampened slightly with water only.
Do not scrub or use any sort of chemical cleaners. Avoid the use of excess water.
Interior walls:
To clean the interior surfaces, wipe with a soft cloth and warm water. After use wipe the waveguide cover in
the oven with a soft damp cloth to remove any food splashes. Built-up splashes may overheat and begin to
smoke or catch fi re. Do not remove the waveguide cover. DO NOT USE A COMMERCIAL OVEN CLEANER,
ABRASIVE OR HARSH CLEANERS AND SCOURING PADS ON ANY PART OF YOUR MICROWAVE OVEN.
NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF YOUR OVEN.
Avoid using excess water. After cleaning the oven, ensure any water is removed with a soft cloth.
Turntable/Roller Stay:
Wash with mild soapy water and dry thoroughly.
Please check the following before calling for service:
. Place one cup of water (approx. 250 ml) in a glass measure in the oven and close the door securely.
_______ ON _______ SEY ?no emoc pmal nevo
eht seoD .A
_______ ON _______ SEY ?krow naf gnilooc eht seoD .B
(Put your hand over the rear ventilation openings.)
_______ ON _______ SEY ?etator elbat
nrut eht seoD .C
(The turntable can rotate clockwise or counterclockwise. This is quite normal.)
D. After two minutes, did an audible signal sound and COOK indicator go off?
YES _______ NO _______
_______ ON _______ SEY ?toh nevo eht edisni retaw eht sI .E
If “NO” is the answer to any of the above questions, please check your wall socket and the fuse in your meter box.
If both the wall socket and the fuse are functioning properly, CONTACT YOUR NEAREST SERVICE CENTRE
APPROVED BY SHARP.
zH05 ,V042–032 es
ahp elgniSegatloV eniL CA
deriuqeR rewoP CA
W* (IEC test procedure)rewoP tuptuO
**)2 puorG/B ssalC( z
HM 0542ycneuqerF evaworciM
)D x H x W( snoisnemiD edistuO
345mm
thgieW
* When tested in accordance with AS/NZS 2895.1:2007
** This is the classifi cation of ISM (Industrial, Scientifi c and Medical) equipment described in the International
Standard CISPR11.
12
SPECIFICATIONS
SERVICE CALL CHECK
CARE AND CLEANING
Turntable
1550W
X X
1
553 326 470mm
17kg
1100
Press the button four times.
START/+30sec./ENTER