(3)
(4)
Srw
SF-7350
(A) Reedtion
Loosen
the No.45 mirrorhoHer holdingmrewe.
Adjustthe No.45 adjustingwrew in acmrding to the resolution
on the copy.
(B) Magnfiicationratio
Adjustment is not r~uired kuee the magnfiatbn ratio
shouH be withinlimitswhen the resolutionis corr-t.
Enlargementand reductim modefocusand megnifbatbn ratio
adjustments
If the ftius and magnificationratio are within the fimits,the
fmus end megnifbstbn ratiowiilalsobe withinthe limitsinthe
enlarge and reduce modes.
OptioalAxb (centerdeviation)chesk-outprodure
1)
2)
3)
4)
Plain a whitesheet of B5 (~li~ x 51J~ onthe d=ument
tebkas shownbdow. (landscape)
r
Donotallowt
ment
to separatetromme
. d-merit table.
/////
“;; E
Copypeper
+
s
Insert an B5 (8-11% x $11%) copy paper in the madine.
(potiait)
Make a copy in the normal mode WW the o~ind cover
v.
NOTE: Do not allow the hatched portionof the dmument
to liftfromthe tabk surface.
Compare the kngth LB wti the length LA of the copy
paper.
n------m
u
Allwhke area
B5 (8-1/%X ~11~ p~~
Alltonedmea
(copy paper)
, +
(q %ti~l $xf$(centerdeviation)adjustment
(SF-7350)
Adjustmentmustbe done by means ofthe ~m guide.
Make the adjustmentby refe~ to the center of the protrusbnon
the baaephte withthe markingon the ~m guide.
.One scale position will vary the optbal axis 2mm in the normal
J
mode (xl .0).
Adjustmentb notr~uired if LA - LB is smalkr than2.Omm.
Shih the lens -rriage towarda the rear frame dde (directionA), if
LA -LB b greater than 2.Omm.
Shti the kns carriage towards the front frame side (diredion B), if
LA -LB is smallerthan 2.Omm.
~ Cam guide
(SF-7300)
Adjustthe Imtion ofthe lens hoMer.
B
—
F.Adjustingengagementof theclutchconnection
gearwtihtheclutchs~ed shiftgear
If the podtfon of the fens ahouH deviate after repladng b kns’or
wire. the dbtena between the kne and the dutd needs to be a&
juetedIn the fotbwfngmanner:
1)Loosen
the dutoh speed shift~
gearholdingtwoset~rews.
l\
8–13
——
To Next Page
Loading...
