Sharp SF-7300 - Page 51

I
m ‘“---”
..--.
SF-7m
SF-73S0
E. Lowerheatroller
(1) Remove the ~rfuser unit,reference to l-A-(l) to (4).
(2) Remove the fuaerpapergukfe B unk(twoscrews).
Fuserpaper gutie B unk
~:$-,~&
%
; , w ..?,. $,
.< I
i
/
w
Frontframe side
Paper gti B unithofdingscrew
Rear frame side
3) Remove the kwer heat roner.
Reerframe side “
~e-aseembly
Do not scratch the fewer heat roller with the smeper, when iw
stallingthe fueerpaper guide B unit.
~ELŠÈÀÔ•Œ¬Ê•„¯Ê•t¬Ê•pELŠð€Õ•p¯Ê•x¬Ê•Make sure that the top end of the scraper is in mntact with the
lowerheat rotteras illustrated.
%
T
Lower
heat rofler
Fueerpe~rgutie B
F. Separatorpawl
(1) Remove the upperfuserunk, referto l-A-(l) to (4).
(2) Remove thetentim spring.
Rotate tb pawf in the arrow direction “a- and match the
machrnd surfaceof the pati shaftto the gutie.
Removethe separatorpewfthroughthe cut Inthe gutie.
Ma&ined sudace ofthe pawfshaft ,./
Tensionspring
~J
, ,.~
A
I
%]
“’ L’;~$/’ .?%
/ a
,L
‘< C*”
1
.-
,,’”
Separatorpawl
Ma&ined aurfaceof the pati shaft
/
/
Gu~e
\
Cutinthe frame
G. Cleaningroller
(1)
Rmove the upperfueerunh, ref-to l-A-(l) to (4).
(2) Remove the fueer pepergutie B, referto l-E-(l) to (2).
(3) Match the machhed surface of the bating and remove the
cleaningrdfer tim the fuserpaper gutie B unit.
Fuserpaper gutie B unfi
10–3
. 7*:--- —--—
-
.