“’-’””’””-=”’=’’-s”2”3’’”’”’-mF~”-*”’F~-“
,,.:.,7.,.,,7 .,~,....*.P-.,-,-
. .
@ Man@v rotatethe mirrorbsse drivegear and bringmirrorbeae
B into mnte~ with the mirrorbase B positioningpkte B. If the
frontframe *of mimr base B mmee in mts~ withthe miti
base B positioningdate at ~ same timees the rearframeside,
: - will.~ m need for ed~etment es it h=. been sd~eted
m.
II
Mma
B
I
II
@ If eitfter end of mirrorbase B is not in ~ntsti wi~ the mirror
base positioningdate B, the fd~ng a- is r~uiti.
II
Mirrorbase
B II
@ been em mirrorbase drive pulleyse-ewe on bothframe
sides.
1
mean -W (frontframe*)
/
bsen -W (rear* 40)
@ mut movingthe mirrorbase d~e pulleyon bornframesides,
rotate the mim base shaft ~ degrees. (Manuaf& mtste the
mirrorbase drfvegear)
‘@ .~ghten the two ~ of the mky whiti the mirrorbase B
_ in ~
~ the mirrorw positioningplate B.
‘@ Manuallyrotatethe otherside PUMYand stW.it* the mirror
base. B -s in m- with the positioning@ate, xthout
movingthe mirrorbees shaft.
10-?
●
●
m i-kng h front h side mirrorbase dtie pulley,
*fheedge of the-
baae drive pulky with the edge of
W miw baas dti *ft.
W i-w the - frame aide mirror base drive Wiley, .
- a ~ of O.Wm
~ the edge (i*e) “ofti f
,rnirrorbase drive pul~ and the E-ring.
_ (F~ frameside) (Resr_ ~)
1
@
*ti-mthem
O.- u
base drivegear to separate~ mirror
. . .
~ ~ B, thenbringitinmnti again.
Ensurein this.~
that bothframe sidesof the miwr base
B ~ in
_ with the mirrorbase ~itiorrim date at the
‘~ ~~e the @ht aide rear panel. ~~• {
emove th _yloperation unit.
of mirrorbase A.
.
- .
t
,,.,,.,,..- ,?, -,,. .
. ...
To Next Page
Loading...
