‘“-
SF-7700
SF–77S0
@ Unlink the rear frame Sde lens holderhookfromthe lens base
and lift up the lens holderto remove.
B. Reassembling the’lens hotier
@ Put the rear frame side lens holderhook intoengagementwith
the lens base.
@ Set the lens slideronto the lens guide rail grme.
@ Press the frontframe side lens holderhook in arrowdi~on A
witha~ewdriverand pushthelsnshotiwin~e mdir*n.
@ Press the lens base shadowedportionend slidethe lens hotier
in arrow dir~on C withsome foru to set Rin the lens base.
@ Manually rotatethelena bssedrive gear- movethe lensbase ~
to fi-k that R mwes smooth~ in bothdirections.
(SF-~00)
Remove two lens ‘~tir Wews end remme the lens hotier from
theoptid systemhesais. ‘
Lenstier
NOTE:
10- 2s
—-——— ... .-—
-- ----
Adiust the horizontalopti=l =is after iristailationof tie
lens, in referenceto Paragraph (3)-9.
(8) MIXllan-us
A
Mlrrw base B.q-
If there istrou~ in the mirrorhoMerof mirrorbeesB, mi~r holder
positioningplate, the whole mirrorbase B unit must be replaced.
m not move the Imtion of the mirror Mder poeitionin9Plate
%ured withthe red~rew.
c
(Mirrorbase)
c
B. Mim base eilder
Thr~didereareud-in mirrorbaeeAandtirin mirrorbeaeB.
wan a mirror base slider has to h r@a@, MW mu~ all @
r** on that mirrorbase at the same time. Setim partsmirror
bass shder(CSU_7FW) ataina four-s of sliders.
~tiertging onw one piw may reeuti in mirror base tilt, loose
in~lstion, image Mur, or image skew.
(MirrorbaseA)
I
.,.....----------------------
! “
To Next Page
Loading...
