SJXF50XT
31
Remove the aluminum tape that fastens the lead 3)
wire to the drip tray.
Screw
Heater AL
Aluminum tape
Screw
Remove two screws, and remove the heater AL.4)
Open the heater fastening part of the heater AL to 5)
the right and left, and replace the heater.
Fastening part
Heater
Insert the lead wire in the groove of the drip tray, 6)
and apply the aluminum tape to fasten the lead
wire.
Lead wire
Aluminum tape
Groove of drip tray
Re-mount the evaporator in the original condition.7)
CAUTION
Put the bottom of the evaporator on the rib of the •
drip tray, and place the projection of the food liner
at the position shown in the figure.
Set the accumulator piping angle as shown in the •
figure.
Make sure that the pipe is not remarkably •
deformed.
Accumulator
Fastening part
VEGETABLE COMPARTMENT 4.
DISASSEMBLY
Main component Contained parts
-
Damper, G-thermistor
(V-thermistor)
Remove the V door.1.
Remove the Damper cover. 2.
Remove one screw.
Pull the Damper cover while inserting a flathead
screw driver, etc., to have some gap.
Flathead screwdriver etc,
Screw
Damper cover
: claw
Remove the Damper.3.
Close the flap if the flap is closed.
Disconnect one connector and pullout the Damper.
Remove the G-thermistor.4.
G-thermistor
Pull out the
connector
Damper
Close the flap
To Next Page
Loading...
