SSC3088AS
25
1. Remove the cabinet. [3] Reference
2. Remove the harness from the motor SW or the primary latch SW
3. Pull out the motor SW or the primary latch SW while expanding the
two claws that retain the motor SW or the primary SW outward at
the same time.
Reference: When removing the motor SW or the primary latch SW, it is
unnecessary to remove the latch SWK.
[8] Door assembly
Removal method
1. Remove the cabinet. [3] Reference
2. Close the door.
3. Remove the left and the right door SPRs.
When removing the door SRR, please remove the downside of the
door SRR from the R hinge K or the L hinge K.
R door cam
Door SPR
R hinge K
Door assembly
Door assembly
Door SPR
L door cam
L hinge K
4. While slowly opening the door, remove the R door cam and the L
door cam from the pin of the door panel DK.
R door cam
Pin of door panel DK
L door cam
Pin of door panel DK
5. Remove the R door cam and the L door cam from the oven DK.
6. With the door opened at over 110°, slide the door leftward and pull the
hinge pin of the door panel DK from the R hinge K and the L hinge K
and remove the door.
Door assembly
Oven front plate
Sliding
direction
110°
Wiring protection cover
Controlling harness
Door assembly
Connector
7. Pull the door assembly toward you and pull out the harness until
the connector hidden in the wiring protecting cover appears.
8. Remove the connector.
Note: After removing the connector, pull out the controlling harness
so that it would not be brought into the wiring protecting cover.
If it is brought in, please turn the main body over, open the
bottom plate and pull out the harness again.
Installation method
1. Connect the harness of the door to the controlling harness and in-
sert the connector into the wiring protecting cover.
Note: Do not reversely insert the connector of the controlling harness
and the connector of the display board harness when connect-
ing them.
2. With the door opened at over 110°, firstly insert the hinge pin on
the right side of the door panel DK into the R hinge K and then slide
the door rightward and insert the hinge pin on the left side.
3. With the door opened at about 45°, hook the R door cam and the L
door cam onto the left/right pin of the door panel DK.
[7] Motor SW and primary switch SW
To Next Page
Loading...
Need help?
General