SSC3088AS
29
1. Remove the door panel DK. [10] Reference
2. Remove the DC fan motor (door) [11] Reference
3. Remove the FPC (flexible printed circuit) coming from the panel
DEC ASS off the connector CN-1 of the display board.
Note: Before removing FPC from the connector, please unlock the
connector.
Flip up the thin long plate attached to the connector to un-
lock.
Unlocking board of connector
Connector CN-1
Connector CN-1
FPC from panel
DEC ASSY
Connector CN-1
4. Remove the display board. (8 screws)
Note: When installing the display board and the DC fan motor
(door), please confirm that the board packing A and the
board packing B have been installed into the door frame.
Additionally, when installing the SW board cover, please
confirm that the board packing C has been installed.
Display board
Board packing A
Door frame
Board packing B
DC fan motor (door)
[13] LCD unit
[FOR REFERENCE ONLY NON-REPLACABLE]
1. Remove the door assembly. [8] Reference
2. Remove the door cover. [9] Reference
3. Remove the door panel DK. [10] Reference
4. Remove the DC fan motor (door) [11] Reference
5. Remove the display board. [12] Reference
6. Release the lock of the connector CN-2 of the display board and
remove the FPC which is inserted into the connector CN-2.
Connector CN-2
Display board
FPC
Claw
Connector CN-2
7. Remove the claws (3x) of the LCD unit from the display board and
turn over the display board.
Note: At this time, do not pull FPC which connects the LCD unit
with the display board.
8. Release the lock of the connector CN-3 and remove the FPC which
is inserted.
FPC of LCD unit
LCD unit
Display
board
Connector CN-3
[14] Door adjustment
1. After installing the door, loosen the screw of the latch base AG and
rotate the main body so the door faces upward.
Note: Underlay it with something soft before rotating it to prevent
To Next Page
Loading...
