Sharp SuperSteam Plus SSC3088AS - Rear Plate Replacement; Engine Unit, Thermo, and Thermistor Replacement

SSC3088AS
31
[17] Rear plate
1. Remove the side cover R, the side cover L, the exhaust cover and
the cabinet. [3] Reference
2. Remove the earth wire. (1 screw)
3. Remove the left/right reinforcing AG. (3 screws each)
4. Remove the screws (5x) which fasten the rear plate to the bottom
plate, the engine unit and the steam duct.
Rear plate
Screw
5. Lift up the upside of the rear plate while pulling its lower end out a
few millimeters, remove the claw of the rear plate from the intake
duct top and remove the rear plate from the claw of the steam duct
cover.
Claw of the steam duct cover
Claw of the rear plate
Upper suction duct
[18] Engine unit, engine thermo,
thermistor (engine)
1. How to remove the engine unit
1) Remove the side cover R, the side cover L, the exhaust cover
and the cabinet. [3] Reference
2) Remove the left/right reinforcing AG and the rear plate. [17]
Reference
3) Remove the steam tube and the pump tube E from the engine
unit.
4) Remove the controlling harness from the following parts.
●Thermistor (oven)
●Sirocco motor (left)
●Engine unit (engine liquid level sensor)
●Thermistor (engine)
5) Remove the main harness from the following parts.
●Engine thermo
●Engine unit (E heater)
6) Remove the nuts (2x) which fix the engine unit to the oven DK.
Harness to engine
water level sensor
Intake tube
Harness of
thermistor
(oven)
Nut
Engine unit
Harness of
sirocco motor (left)
Pump tube E
Harness of
thermistor (engine)
Harness to engine thermo
and engine unit (E heater)
Position of nut
2. How to remove the engine thermo
1) Remove the engine unit. (Refer to “1. How to remove the engine
unit”)
2) Remove the screws (2x) which fix the engine thermo to the en-
gine unit.
3. How to remove the thermistor (engine)
1) Remove the engine unit. (Refer to “1. How to remove the engine
unit”)
2) Remove the engine cover. (1 screw)
3) Remove the thermistor (engine) from the engine unit. (1 screw)
Note: When installing the engine cover after attaching the thermis-
tor (engine), lead the harness of the thermistor (engine)
through the hole of the engine cover. At this time, make
sure the harness of the thermistor (engine) is not nipped
by the engine cover. Additionally, after screwing the engine
cover onto the engine unit, confirm that the braided glass
tube (white tube part) of the harness of the thermistor (en-
gine) is protruding.
Engine cover
Engine unit
Screw