E 13
Manual Channel Preset (PRESET USING BY CHANNEL NUMBER)
1. Depending on the programme channel you want to
preset, press SINGLE/DOUBLE entry to select
single/double digit entry.
2. Select the programme channel number you want to
preset with the 0 ~ 9 NUMBER buttons.
3. Press MENU to see the MAIN menu.
4. Press BLUE to see the TUNE menu.
5. Press Volume UP/DOWN to select (with white
letters) the Channel type: CH (Aerial) or CC (Cable).
To select channel “5A”, press 5 and then press
RED.
6. Press CH DOWN to select SEARCH.
7. Press Volume UP/DOWN to start preset.
The tuning sequence will stop when a signal is
detected, if the signal is not the required channel
press Volume UP/DOWN to continue.
8. Press GREEN to memorize.
9. Press MENU to clear the on-screen display.
Repeat the above procedure for presetting other programme
channels.
To Next Page
Loading...
