Sharp SX66NF8 - Aerial Connections - TV Set Only; Aerial Connections - VCR and TV

E 6
Aerial Connections - TV set only -
To enjoy a clearer picture, we recommend that you use an outdoor antenna. The following is a brief
explanation of the types antenna connections:
Aerial Connections - VCR and TV -
You can also connect the TV set to the tuner on a VCR using the connection shown below.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable) (not supplied)
300-ohm twin-lead
flat feeder
(not supplied)
75-ohm impedance
converter
(not supplied)
TV
VIDEO
AUDIO
OUT AV-1 IN AV-2 IN
Y
P
B
(C B )
P
R
(C R )
COMPONENT
L
R
Antenna in
TV
VIDEO
AUDIO
OUT AV-1 IN AV-2 IN
Y
P
B
(CB)
P
R
(CR)
COMPONENT
L
R
VCR
To antenna in
terminal
To RF out
terminal
Antenna in
(1) 75-OHM COAXIAL CABLE:
Connect the cable from the antenna to a standard DIN45325 plug
(IEC 169-2) and plug directly into the antenna socket on the rear of
the TV set.
(2) 300-OHM RIBBON CABLE:
Connect the cable from the antenna to a balun (Balanced Transformer)
and plug directly into the antenna socket on the rear of the TV set.
• Remove the power cord from the electrical outlet before connecting the antenna to the rear of the TV set.
• When using the RF terminal connection, set the TV to channel zero to make initial adjustments for the VCR.
• Turn off the power on the TV set and the VCR being connected before making the above connections.
Be sure the cord plugs are fully inserted in the connection terminals.
• See the operation manual of your VCR for connection details.
SX66/76NF8(01-)new 02.10.22, 4:03 PM6