Sharp UP-600 - Page 35

Reports/Batch Commands
Page / 33
Designs and specifications are subject to change without notice.
05/2002
X2/Z2
X1/Z1
MGR
REG
OP,X/Z
PGM1
OFF
PGM2
(SRV)
(SRV')
OP
SM
MA
SRV
4. Change Batch:
Place the SM or MGR key to the X1/Z1 position
1) Select 7 CAT
2) Select 1 CAT#2
3) Select 1 BATCH EXECUTE
4) Select 4 CHANGE BATCH
5) Enter the instructed Batch No. (4 dig. max) followed by depression of the [ENTER] key.
6) Upon successful execution, the POS will return to the BATCH EXECUTE sub-menu.
7) To exit, depress the [CANCEL] key until the POS returns to the X1/Z1 menu.
1234
Note: The above operation is usually used in the event a replacement Data Tran is installed or as the result of a
Network request. Please do not initiate this command unless advised to do so.
X1/Z1
5
[ Example Report]
YOUR RECEIPT
THANK YOU
0 9 / 0 1 / 2 0 0 1
#0148 9:33PM
* X 1 *
000001
CHANGE BATCH
CHANGE BATCH
Name of Inquiry Report
New Batch No.
0008