UP-810F/820N/820F(U) SRV MODE PROGRAMMING (“SETTING”)
3 – 4
DEVICE CONFIG - 10. BCR (SCANNER)
* ER-A61HS1 setting : “BAUD RATE = 4800 bps” , “DATA BITS = 7Bits”, “PARITY = ODD”, “STOP BIT = 1Bit”
DEVICE CONFIG - 11. BERG (BAR) / SCALE / COIN DISPENSER / ONLINE
DEVICE CONFIG - 12. PERPAID CARD / ONL ACCT BAL
Details are omitted.
DEVICE CONFIG - 13. IC CARD
DEVICE CONFIG - 14. POLE DISPLAY
DISPLAY CONTENTS SELECT ITEM MRS NOTE
CHANNEL# Channel No. 0 - 4 0 0: No RS-232 channel is assigned.
BAUD RATE Transmission speed 4800 bps 4800 bps
9600 bps
19200 bps
DATA BITS Data bit 7 Bits 7 Bits
8 Bits
PARITY Parity bit NON ODD
EVEN
ODD
STOP BIT Stop bit 2 Bits 1 Bit
1 Bit
DISPLAY CONTENTS SELECT ITEM MRS NOTE
CHANNEL# Channel No. 0 - 4 0 0: No RS-232 channel is assigned.
DISPLAY CONTENTS SELECT ITEM MRS NOTE
CHANNEL# Channel No. 0 - 4 0 0: No RS-232 channel is assigned.
DISPLAY CONTENTS SELECT ITEM MRS NOTE
WAITING TIME Waiting time until message is display-
yed on POLE.
0 - 999 0 3 digits (0 to 999 seconds)
0 (No display)
To Next Page
Loading...
