ms
Setting the Clock
When you use the VCR for the first time or after a power
failure of more than 60 minutes the clock will be reset.
Apply power to the unit to power on (see page 5,
item 3) and press MENU. Then perform the following
procedure.
PREPARATION
l Select the video channel on your TV.
And turn on the VCR. (See page 5, item 3.)
Initial Setting
of
Clock
0
First set the language (refer to page 9). Then press SET. Go to step
0.
Changing
the
Clock Setting
Clock Setting
-
continued
Numeric
buttons
@ Select whether the clock should show 12-hour AM/PM
time or 24-hour time by pressing
A/V,
and then press
. .
Ex.:
12H
INoTE>
l
“24H”
,,,.......................... 24.hour display.
l
“12H”
,,,,,........................ 12.hour AM/PM display.
l 12H (AM/PM) mode is preset at the factory.
@ Set the present time with the numeric buttons or
A/v
on
the remote control and then press
b.
(First set the ‘hour’
digits and then the ‘minute’. If there is only one ‘hour’ or
one ‘minute’ digit, enter a 0 first.)
Set AM or PM, using
AM/PM.
(12 hour)
Ex.:
10:28AM
iNoTE>
l If 12H mode was selected, then set the AM/PM indicator.
@ Set the date with the numeric buttons or
A/v
on the remote
control, and then press
b.
(First set the ‘day’ digits and then
the ‘month’. If there is only one ‘day’ or one ‘month’ digit,
enter a 0 first.)
Ex.: Dec. 15
(1.6712)
@ Set the year digits with the numeric buttons or
A/v
on
the remote control. (Enter the last two digits of the year.)
Ex.: 98
@ Press SET. To return to the normal screen, press MENU
10
To Next Page
Loading...
