Sharp VC-A220X - Recording with the Timer

q
Recording with the Timer
The timer can be set manually for automatic recording of up to 8 events over a 365 day period.
PREPARATION
.Select the video channel on your TV. Turn on the VCR (See page 5, item 3).
l Load the cassette, ensuring the erasure protection hole is covered. The VCR power will automatically turn on.
l Check that the clock is displayrng the correct time. (See Setting the Clock on page IO.)
PROCEDURE
Example: Recording channel position 47 in SP mode from 12:OO PM to 12:30 PM, December 15, 1998, if the
present time is lo:28 (morning), December 14, 1998.
1
[Menu]
[Timer position]
..,.. .:.. . . .
..,.. .:.. .:..
..,.. .:.. .:..
..,.. .:.. .:.~ ~~
GA420X
0 Press MENU.
Select the TIMER-setting mode and press SET
@ Select the timer position with A/v and press SET.
l If the timer positions 1 to 4 have already been set, the
screen changes 2/2 (timer positions 5 to 8).
@ Set the date for timer recording with the numeric buttons
or A/v on the remote control and then press b.
l First set the “day” digits and then “month”. If there is
only one “day” or one “month” digit, enter a 0 first.
@ If you want to record only once, press b and go to step
0. Otherwise, select “D (DAILY)” to record at the same
time each day or “W (WEEKLY)” to record at the same
time each week by pressing A or v, and then pressing
. .
@ Set the channel number using the numeric buttons or A/
v and then press . .
1NoTE>
*To record audio and video from an external source through the
AUDIO/VIDEO terminals on the VCR, press A/V to select the AV
channel. (When the AV position is selected, “AV” is displayed where
a channel posrtion number is usually displayed.)
l A/r can also be used to set the date and time instead of the numeric buttons
l Press 0 first if the day, month, hour or minute is a single digit.
Continued on next page
22