q
Simple Recording Timer
There are two ways to use this Simple Recording Timer for
l Immediate recording.
your convenience.
Convenient when having an unexpected visitor or
telephone call.
l Delayed recording:
Immediate Recordina
Convenient when leaving the house or going to bed
0
Select the channel position to be recorded by pressing
CHANNEL
A/V.
(Ex.:
Channel position: 2)
@ Press REC to enter the normal recording mode. Then,
press REC repeatedly to set the desired ending time.
(Ex.: Ending time:
9:30
AM)
INoTE>
l
Each press of REC increases the stop
trme
by
IO
minutes.
l Press STOP to terminate recording
Delayed Recording
GTANDBY
@ Select the channel position to be recorded by pressing
CHANNELAIV.
(Ex. : Channel position: 2)
@
Set the starting time by pressing
aTIME.
(Ex.: Starting
time:
8:40
AM)
INoTE>
l
Each press of
BTIME
Increases the start time by
10
minutes.
*Setting the time within a 24-hour period in IO-minute intervals is
possible.
@
Set the ending time by pressing REC. (Ex.: Ending time.
9:30
AM)
INoTE>
l Each press of REC
rncreases
the stop time by
IO
minutes.
@
Press STANDBY to turn to the POWER STANDBY mode.
(See page 5, item 2.)
(Ex.: Present time:
8:28
AM)
l After the Simple Recording Timer is set, the channel position cannot be changed
*To
confirm the starting time and the ending time, first turn on the power. Then press
OTIME
to confirm the startrng and
ending time. And turn to the POWER STANDBY mode.
l To clear the Simple Recording Timer setting during setting of “Delayed Recording”, press CLEAR on the remote control. To
clear after setting, turn on the power, press
QTIME
to select Simple Recording Timer mode, and then while the t3START
time IS flashing, press CLEAR.
*The Simple Recording Timer cannot be set
rf
the timer has been preset (“m’” indicator on the VCR display is lit)
If this is the
case, cancel the timer standby mode by pressing TIMER ON/OFF, turn on the power and then proceed with setting of the
Simple Recording Timer
Only
fur
VC-A42OX
*
Seiect
the
SP
(Standard
Ptay)
or
LP
(tong
Play>
recording speed
with
TAPE SPEED on the
remote
cclntrol
(“SF
of
“LP”
will
tight up an the
VCR
dispky).
SP
(Standard
PfayJ
gives the best picfure quality.
LP
<long Play) gives the lafgest recardlng
time.
l The stop time for delayed recording must be set within 10 seconds of setting the start time, otherwIse start time must be set
again.
21
To Next Page
Loading...
