Sharp VC-A220X

ISa
Setting the Channels
Your VCR can receive VHF channels 0 to 12, and UHF channels 28 to 69. Your VCR has 48 programmable
channel positions, each of which can be set to any of the above broadcast channels. The channel positions have
been preset at the factory as shown below.
l Use the A / 7 / 4 / F buttons on the remote control to set
the OSD.
l Channel position numbers 1, 3. 4, 8, 11 to 27, and 29 to 46
have been factory set to be skipped when CHANNEL A
or V is used
l If the picture is not clear, if you want a different channel
from the one preset or if you wish to reset a skipped
channel, reset the channel as follows
AUTO TUNING
PREPARATION
l Select the video channel on your TV. And turn on the VCR. (See page 5, item 3.)
“CHANNEL PRESET” with A/V, and press
Select item “AUTO” with A/Y and press SET.
l CHANNEL
PRESET has been
preset to MANUAL at the
The channel display on
the TV screen
will continue
through all of the channels and when finished, the TV
screen will return to the normal screen.
The bar display indicates the estimated amount of
channels tuned.
l If additional unwanted channels were found, refer to page 13 to skip unwanted channels
l If some channels were unable to be found, refer to page 12 for Manual Tuning.
11