m
VCR Display
When DISPLAY is pressed, the display changes in the following way. (However, the following is the case when
the clock time is set and displayed in the
12-hour
system.)
ExamDIe:
[TAPE COUNTER/CHANNEL]
ExamDIe: [TAPE
REMAINING/CHANNEL]
*
Example:
T
[OPERATING MODE/CHANNEL]
4
Example: [PRESENT TIME/CHANNEL]
+
l During
trmer
recording or Simple Recording Timer, the display shows the record finish ti
d, the
display changes in the following way.
(If the “B” indicator on the VCR display is lit, cancel the timer standby mode by pressing TIMER ON/OFF and then turn on
the power.)
Example,
[REMAINING TIME]
Example: [PRESENT TIME]
+
+
l During Simple Recording Timer recording,
“m”
lights.
Counter Clear
Make sure the counter is displayed, then press CLEAR on the remote control.
“O:OO.OO”
is displayed.
INoTE>
l The counter will reset to “0.00.00” when the tape is rewound completely.
28
To Next Page
Loading...
