Sharp VC-MH713HM - Page 11

8
If problems persist contact the SHARP Helpline on tel: 0990-274277
INSTALLING YOUR VCR
INSTALLATION CONTINUED
.
The clock setting screen will now appear.
To set the time and date follow the steps below:
1.
Press the [ / ] menu select
buttons to select either 12 or 24 hour
clock operation.
2.
Press [ / ] to select TIME. Enter
the time using the
NUMBER
BUTTONS
or the [ / ]
buttons. If the minutes or hours are
less than 10, enter the leading 0. If
using the 12 hour clock enter AM or
PM by pressing the
AM/PM
button on the remote control.
3. Press [
/
] to select DATE. Enter
the date using the
NUMBER
BUTTONS or the [ / ]
buttons. For example, for 1st April
enter
01 04.
4. Press [ / ] to select YEAR. Enter
the last two digits of the year using
the
NUMBER BUTTONS or the
[ / ] buttons. For example, for
2000 enter
00. For the year 2001
enter
01.
5. Press the button to store the time
and date.
NOTE:
✔
All the programmes should now be correctly tuned in and the clock set.
• You will need to update the clock for Winter/Summer daylight saving.
MENU SET
CLEAR
DISPLAY
INPUT SELECT
CHANNEL AM/PM
PLUSCODE
MODE OSD
231
4
7
5
8
0
6
9
12 hour example:
24 hour example:
CLOCK
MODE T I ME DATE YEAR
24H 15:0501/0400
MODE : 2 4H / 1 2H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
CLOCK
MODE T I ME DATE YEAR
12H 03:05PM 01/04 00
MODE : 2 4H / 1 2H
 : SELECT  : CHANGE
SET : ENTER MENU : EX I T
Remote Control
AM/PM
SET
VC-MH713HM.book Page 8 Monday, May 8, 2000 11:53 AM