Sharp VC-MH713HM

27
If problems persist contact the SHARP Helpline on tel: 0990-274277
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1.
Press the
MENU
button.
2.
Press the [ / ] menu select buttons
to select SET UP. Press the
SET
button
to confirm.
3.
CHANNEL PRESET
will be
highlighted. Press the
SET
button.
4.
Press [ / ] to select
CHANNEL
.
5.
Press
[/]
to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press
[/]
to continue tuning.
6.
Press [ / ] to select
FINE
TUNING
. Press and hold
[/]
until
the sharpest colour picture is obtained.
IMPORTANT NOTE:
7.
If you connect an independent decoder,
you must press [ / ] to select
DECODER, then select
[/]
to turn
the decoder function ON.
8.
Press [ / ] to select
SKIP
.
The SKIP function determines whether the
channel can be selected when using the
CHANNEL
/ instead of the
NUMBER BUTTONS
.
9.
Press
[/]
to select ON or OFF for
this option.
10.
Press
SET
to confirm.
11.
Press
MENU
to leave this function.
CHANNEL PRESET
CHANNEL SORT
CLOCK
➔
PRESET 1
CHANNEL CH 2 1
FINE TUNING
▲
▲
DECODER ON OFF
SKIP ON OFF
SET
SET
CHANNEL
CHANNEL
MENU SET
CLEAR
DISPLAY
PLUSCODE
MODE OSD
TIMER
ON/OFF
AUDIO
OUT
SKIP
SEARCH
ZERO
BACK
231
SET
Remote Control
Module 15.fm Page 27 Monday, May 8, 2000 3:05 PM