23
If problems persist contact the SHARP Helpline on tel: 0990-274277
ADVANCED OPERATION
SEARCHING THE VIDEO TAPE
SKIP SEARCHING THE VIDEO TAPE
You can search the tape in 30 second time intervals. To do this follow the procedure below:
1. Press PLAY/X2 to start the video tape playing.
2. Press the SKIP SEARCH on the remote
control.
The number of times you press
SKIP SEARCH
determines the forward search time.
• After searching, normal playback
will resume automatically
DIGITAL PROGRAMME SEARCH SYSTEM (DPSS)
Your VCR records a marker signal on the tape at the start of each recording. These signals can
be used later to locate the starting point of a recording.
Press
DPSS to locate a previous programme or the next programme.
For example,
1. Load the video tape into the VCR.
2. Press DPSS three times. The number 3 will appear on the on-screen display, and the
VCR will fast forward to locate the third recording after the current one.
3. Press DPSS once. -1 will appear on the on-screen display and the VCR will rewind to
locate the beginning of the current recording.
4. To cancel the search before it has finished, press STOP or PLAY/X2 .
NOTES:
• Recordings must be longer than 3 minutes.
• The starting point of playback may vary.
• This feature will only work with video tapes recorded on a VCR with the DPSS feature.
PLAY / X2
1 press = 30 seconds.
2 presses = 1 minute.
3 presses = 1 minute 30 seconds.
4 presses = 2 minutes.
SKIP
SEARCH
SKIP
SEARCH
/
-1
+1
+2
+3
RECORDING 5
RECORDING 4
RECORDING 3
RECORDING 2
RECORDING 1
DPSS
Signals
Current tape position
Fast ForwardRewind
DPSS
Number
STOP
PLAY / X2
VC-MH713HM.book Page 23 Monday, May 8, 2000 11:53 AM
To Next Page
Loading...
