5
If problems persist contact the SHARP Helpline on tel: 0990-274277
INSTALLING YOUR VCR
TUNING THE TV INTO THE VCR
1.
Press the
STANDBY
button to ensure your
VCR is in the STANDBY mode. The display on the
front of the VCR should show “
SHARP
”, if not,
please perform the VCR RESET procedure on
page 35.
2.
Press and hold the button located on VCR
front panel for 3 seconds.
The VCR will search and display an ideal
channel.
Wait for the flashing channel number to appear on the VCR display, this number will be
between 21 and 69.
CAUTION:
If the clear button is pressed at this point it will not allow the TV to be tuned to the VCR. Refer
to RF through ON/OFF on page 35.
3.
Switch on the
TV
.
4.
Select the next available or unused channel on your TV, this will become the dedicated
video channel.
Example of
TV channels
5.
Tune the selected channel on your TV until the screen below appears.
(Refer to your TV manual for instructions on how to tune in your TV).
Store this as your VCR channel.
6.
Press the button to place the VCR back into STANDBY. (The MENU screen will not
be displayed when the VCR is in STANDBY mode.)
1 = BBC1 4 = Channel 4
2 = BBC2 5 = Channel 5
3 = ITV ? = VCR
MENU SCREEN
ME N U
V I DEOPLUS
TIMER
MOD E
SET UP
: SELECT
SET :ENTER MENU :EX I T
EXAMPLE
(Blue background
with white text)
Module 03G.fm Page 5 Tuesday, May 9, 2000 4:16 PM
To Next Page
Loading...
