Sharp VC-MH713HM

17
If problems persist contact the SHARP Helpline on tel: 0990-274277
BASIC OPERATION
HOW TO CHECK, CHANGE AND CANCEL A DELAYED
RECORDING
Before you start!
• If appears on the VCR display, press the TIMER ON/OFF button to remove
the symbol.
CHECKING A RECORDING
1. Press STOP to switch on the VCR.
2. Press the MENU button.
3. Press [ / ]to select TIMER. Press the SET
button to confirm.
• All the delayed recordings in the VCR’s memory
will be shown.
4. If the settings are correct press the MENU
button to exit.
• If you wish to change or cancel any settings,
follow the procedures below.
CHANGING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING.
2. To change a delayed recording, press
[ / ] to highlight the recording, then press
the
SET button to select.
3. Press [/] to highlight the setting to be
changed and correct it by using the [ / ]
or the
NUMBER BUTTONS.
4. When all corrections are complete press the
SET button to confirm, then press the
MENU button to exit.
CANCELLING A RECORDING
1. Follow steps 1 to 3 of CHECKING A
RECORDING.
2. To cancel a delayed recording, press
[ / ] to highlight the recording to be
cancelled, then press
CLEAR.
3. Press the MENU button to exit.
NOTE:
• If there are some programmes to be recorded, do not forget to press TIMER ON/OFF
button to return the VCR to TIMER STANDBY mode.
TIMER
ON/OFF
MENU SCREEN
TIMER
MOD E
SET UP
 : SELECT
SET : ENTER MENU : EX I T
STOP
SET
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
SET
SET
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
TIMER
ON/OFF
VC-MH713HM.book Page 17 Monday, May 8, 2000 11:53 AM