Sharp ViewcamZ VL-Z3H

57
Advanced Features
Setting the
Camcorder to Full
Auto Mode
Available modes:
Tape Camera, Card Camera
You can set all manual settings, including
white balance, iris, gain, but not focus, to
Full Auto mode in one operation.
1 In Tape Camera or Card Camera
mode, press the DISPLAY button until
the mode screen appears.
2 Press l or m on the Operation
button to select “MANUAL SET”, then
press the centre of the Operation
button (see page 53).
3 Press l or m to select “EXECUTE”,
then press the centre of the Operation
button.
4 Press l or m to select “FULL
AUTO”, then press the centre of the
Operation button.
W HITE BAL.
IRIS
EXECUTE
LOCK
GA I N
FULL AUTO
RETURN
+
3dB
F4 0.
W HITE BAL.
IRIS
GA I N
FULL AUTO
RETURN
EXECUTE
AUTO
AUTO
AUTO
5 Press l or m to select “EXECUTE”,
then press the centre of the Operation
button.
6 Press the DISPLAY button to turn off
the MANUAL SET screen.
Note:
• You cannot select “FULL AUTO” when no
manual settings are currently in use.
W HITE BAL.
IRIS
EXECUTE
GA I N
FULL AUTO
RETURN