Sharp VL-PD3U User Manual

VL-PD3U
l Measurement terminal:
EE output
l Address:
“0018” INDOOR W/BR
“001 A” INDOOR W/BR
l Measuring instrument:
Vector scope
l Object:
G rey scale
l Data variation width:
“0000” to “03FF”
l Address:
“012B” CGIN RYG
“012D” CGIN BYG
“0128” CMAT RYG
“0126” CMAT BYG
l Measuring instrument:
Vector scope
l Object:
Waveform monitor color bar chart
l Data variation width:
“0000” to “OOFF”
(1) Color gain adjustment is performed
Red amplitude
Blue amplitude
Adjustment address
2.16 rs: 0.05 time (burst ratio)
: “012B”
1.20 + 0.05 time (burst ratio) : “012D”
104O + I0
= “0128” .
335O k 2O
n “0126”
.
.
(9)Auto white balance adjustment
l Measurement terminal:
EE output
l Address:
“006A” OUTDOOR R
“006C” OUTDOOR B
l Measuring instrument:
Vector scope
l Object:
G rey scale
l Data variation width:
“0000” to “03FF”
(l)The color temperature conversion filter (LB165) is mounted in front of lens.
(2) Indication of vector scope is observed in the grey scale standard record state, and
an adjustment is made so that the luminous dots are located in the following
positions:
@I
After completion of adjustment
set the regular
operation mode
., . . .
(the data ” / ,,,__ _ \ ,.,. i FF”, is
written
in the
address
“OOBO”.)
Write the data ” L$‘“‘~ FF” to adress “0133”, and power (out of battery 0 adapter) ON/OFF. Remove the case of lithium with it, put
back the lithium &&that put into power ON/OFF.
10-19

Sharp VL-PD3U Specifications

General

Brand	Sharp
Model	VL-PD3U
Category	Camcorder
Language	English