VL-PD3U
7.
Guide roller assembly
S pole base assembly
G
Q
451
Tu pole base assembly
S loading arm assembly
S pressure spnng
S loading gear
‘.\&Tu loading arm assembly
Tu pressure spring
Tu loading gear
Item
Tightening torque Quantity
F @ CWar0.7~02.2-to.25 2
SmN*m
Ml .2 x L1.8 (Tentative tightening)
3.
(3) Loading mot
assembly
(2) PB guide spring
utface, rearsutface
side surface)
) Drum base sub assembly
Item
Tightening torque Quantity
A 9 S Tight - Ml .4 x L3
70mN-m 4
H v Special screw with step.
7OmN.m 1
M-l .4 x L6.25
Tightening torque Quantity
A 9 S Tight . Ml .4 x L3 70mN-m
1
P 9 S Tight . Ml .4 x L4
70mN.m
1
9-5-2. Reassembly in side of the Slide chassis.
Note) Numbers before part names are given as a guide to the order of assembly.
As for greasing/oiling/cleaning places refer to the attached drawings (Grease/Oil application Fig. 3,4).
(8) S reel base Ass’y
(9) Tu reel base Ass’y
(9) J (@-@I
s
(1) Slide chassis assembly
with sensor FPC
Item lightening torque Quantity
B 8 S Tight l Ml .4 x L2 4OmN-m 1
I Q cw00.%01.8-to.1
2
J @ Ws1.2-02.5to.3
2
95
(I
To Next Page
Loading...
