Sharp W/DIVX Series - Electrical Adjustments

2. BASIC ADJUSTMENTS
Prepare the following measurement tools for electrical
2-1: WHITE BALANCE
adjustments.
1. Place the set in Aging Test for more than 15 minutes.
1. Pattern Generator 2. Receive the gray scale pattern from the Pattern
Generator.
On-Screen Display Adjustment
3. Press the INPUT SELECT button on the remote control
to set to the AV mode.
1. Press the MENU ---> 1147 button on the remote control. 4. Using the remote control, set the brightness and
2. Press the DOWN button on the remote control. contrast to normal position.
3. Select the "PICTURE" menu, then press ENTER button 5. Press the MENU ---> 1147 button on the remote contro
l
on the remote control. 6. Press the DOWN button on the remote control.
4. Press the DOWN button on the remote control. 7. Select the "PICTURE" menu, then press ENTER button
5. Select the "W/B ADJUST" menu, then press ENTER on the remote control.
button on the remote control. 8. Press the DOWN button on the remote control.
6. The display adjustment mode on the screen as shown 9. Select the "W/B ADJUST" menu, then press ENTER
in Fig. 1-1.
button on the remote control.
10. Press the UP/DOWN button on the remote control
to select the "R GAIN", "G GAIN", "B GAIN",
"R OFFSET", "G OFFSET" or "B OFFSET"
11. Adjust the LEFT/RIGHT button on the remote control
to whiten the R GAIN, G GAIN, B GAIN, R OFFSET,
TEMPERATURE COOL
G OFFSET and B OFFSET at each step tone
sections equally.
MODE AV
12. Perform the above ad
j
ustments 10 and 11 until the whi
ELECTRICAL ADJUSTMENTS
1. ADJUSTMENT PROCEDURE
W/B ADJUST
j
R-GAIN 115
color is achieved.
G-GAIN 128
B--GAIN 128
R-OFFSET 1024
G-OFFSET 1024
B-OFFSET 1024
Reset
BD_VST59_91A
Fig 1-1
D-1