XE-A21S OP X/Z, X1/Z1, X2/Z2 MODE
3 – 1
CHAPTER 3. OP X/Z, X1/Z1, X2/Z2 MODE
Roughly speaking, the following sales reports are available:
1) OP X/Z reports (Individual cashier reports)
2) X1/Z1 reports (Daily total X and Z reports)
3) X2/Z2 reports (Periodic total X and Z reports)
4) Flash-read reports (Display sales amount)
In addition to the above reports that are to be used for program check-
ing are also available.
[Purpose]
The reports are each used to check sales data. The standard purposes
of taking these reports are as follows:
OP X/Z reports : These reports are taken by operators in order to
report their own sales data.
X1/Z1 reports : These reports are taken by the supervisor or manager in
order to check and report daily sales totals at that point.
X2/Z2 reports : These reports are taken by the owner or manager in
order to check and report periodic (weekly or monthly)
totals.
Flash-read : These reports are taken by the owner or manager in
order to check and display sales totals at that point.
[Operation]
In the table below those reports marked with a circle “{” can be executed.
PRINTING REPORT
FLASH READING REPORT
OTHERS OPERATION
REPORT NAME
KEY
ENTRY
MODE
DATA FOR READINGOPX/Z X1/Z1 X2/Z2
XZX1Z1X2Z2
GENERAL [CA/AT] {{{{ *1, *6
PLU BY RANGE [PLU] {{ PLU CODE *1, *2
CRERK (ALL) [CLK]# {{ *1
CRERK (INDIVIDUAL) [CLK]# {{ *1, *3
HOURLY (ALL) [#/SBTL] {{ *1
REPORT NAME KEY ENTRY
MODE
DATA FOR READINGOPX/Z X1/Z1 X2/Z2
XZX1Z1X2Z2
DEPARTMENT [DPTn]
or [SHIFT] 3 [DPTn]
or NK 3 [DEPT#]
{
DEPT CODE
*4
CID [@/FOR] { *4
PAID TOTAL [CA/AT] { *4
REPORT NAME JOB#
MODE
DATA FOR READINGOPX/Z X1/Z1 X2/Z2
X Z X1 Z1 X2 Z2
EJ report (ALL) 700 {{{{ *5, *6
EJ report (Latest 10 records) 710 {{ *5, *6
MODE: X : Daily operater X report Z : Daily operater Z report
X1 : Daily X report Z1 : Daily Z report
X2 : Periodic X report Z2 : Periodic Z report
(X report): The corresponding data is held in the ECR.
(Z report): The corresponding data is cleared in the ECR.
To Next Page
Loading...
