XE-A21S OP X/Z, X1/Z1, X2/Z2 MODE
3 – 3
ELECTRONIC JOURNAL REPORT
This job is own to print and clear EJ memory in X1/Z1 mode and OPXZ mode.
[Key sequence]
1) Reading and resetting of all records:
[OPXZ, X1/Z1 mode]
2) Reading of the latest 10 records:
[OPXZ, X1/Z1 mode]
[ACTION]
It prints all or parts of printing data in EJ memory.
The printing format is same as each operation.
It is able to print and clear the EJ memory at general Z1 report by PGM
mode programming.
In that case, the contents of EJ memory is printed just after issued gen-
eral Z1 report.
(Issuing general Z1 report 3 Clear daily DEPT & TRANS memory 3
Issuing EJ memory 3 Clear EJ memory)
[Report cancel function]
It can be cancelled by turned the mode switch to MGR position while EJ
data is printed. (In this case, the contents of EJ memory are not cleared.)
[Key Sequence of SD Jobs]
(*1) When [SBTL]-key is pushed, ECR prints the confirmation
message at “RECEIPT” (not print at JOURNAL) and enforces to
select either executing or canceling this job. The buffered keys are
cleared.
(*2) “1” is a keyword to execute this job.
(*3) If the MODE SWITCH is turned to another mode from X1Z1
position or the AC POWER is off when job is executed, the job is
cancelled.
Note: If AC POWER is off when ECR accesses SD CRAD, the contents
in SD CARD may be broken.
The action of each job is as below.
[JOB#650] Sales data saving
All sales data (Daily and term) save in SD card.
This job is used for the purpose of using Electric Journal Data at the
“Customer Support Tool” software on PC. Maximum 400 times data is
kept in SD Card when the SD memory is not full.
The action is as below.
Step1) After reading the information of the current sub-folder in
“SRECORD.REC” file, ECR creates the new sub-folder under
the folder for “Sales Data”.
Its folder is named ASCII Character that is indicated the number
of sales data in SD Card. (Example: “1”, “2”, “3”,......)
Step2) Save the below data in new sub-folder that is created above step.
Spet 3) Create the “STATUS.REC” file in new sub-folder
when all files are saved completely.
Step 4) Update the “SRECORD.REC” file for changing the structure of
sub-folder.
(*1) The contents of each file are same as the communication data of
“ONLINE FUNCTION”. Details of “File No.” and “Table No.” are
described in “ONLINE SPECIFICATION”. All data are converted to
use at “Customer Support Tool” software on PC.
Note: Each files are used only for the “Customer Support Tool” soft-
ware on PC. Any users dose not need to concern its contents.
[JOB#750] Electric Journal Saving and Clearing on memory
Electric journal data is saved in SD card.
This job is used for the purpose of using Electric Journal Data at the
“Customer Support Tool” software on PC. Maximum 400 times data is
kept in SD Card when the SD memory is not full.
Note: After saving EJ data, ECR is clear the Electronic Journal memory.
xxx: JOB code
650: Save Sales Data (ECR 3 SD)
750: Save and Clear EJ Data (ECR 3 SD)
yyy: JOB code
740: Printing EJ Data on SD (ECR 1 SD)
CA/AT@/FOR
(Reading)
(Resetin
To Next Page
Loading...
