Connections and Setup
-25
Up
Down
Setup
Using the Adjustment
Feet
The height of the projector can be adjusted
using the adjustment feet at the front and back
of the projector when the surface the projec-
tor is placed on is uneven or when the screen
is slanted.
The projection of the image can be made
higher by adjusting the projector when it is in
a location lower than the screen.
1 Press HEIGHT ADJUST.
2 Lift the projector to adjust its
height and remove your finger
from HEIGHT ADJUST.
3 Rotate the adjustment feet at
the back of the projector for
fine adjustment.
Note
•
When returning the projector to its original
position, hold the projector firmly, press
HEIGHT ADJUST and then gently lower it.
• The projector is adjustable up to approxi-
mately 12 degrees on the front and 3
degrees on the back from the standard po-
sition.
Info
• Do not press HEIGHT ADJUST when the
adjustment foot is extended without firmly
holding the projector.
• Do not hold the lens when lifting or lower-
ing the projector.
• When lowering the projector, be careful
not to get your finger caught in the area
between the adjustment foot and the
projector.
HEIGHT ADJUST
button
Adjustment feet
Adjustment foot
To Next Page
Loading...
Need help?
General
