-72
Canceling the Keylock
Setting
When the Keylock Level is set to “Normal”,
all buttons are functional.
Select “Keylock Level” in the “Options
(2)” menu on the menu screen and set
“ Normal”
.
➝ For operating the menu screen, see
pages 42 to 45.
Note
• When a password has been set, and
“Keylock Level” is selected, the password
input box will be displayed.
• If both a password and the Keylock Level
have been set at the same time, the pass-
word will be necessary before changing
the Keylock Level.
Selecting the Transmission Speed (RS-232C)
This menu allows you to adjust the transmission speed of the RS-232C connection by select-
ing the baud rate.
Selecting the Transmis-
sion Speed (RS-232C)
Select “RS-232C” in the “Options (2)”
menu on the menu screen.
➝ For operating the menu screen, see
pages 42 to 45.
Note
• When a password has been set, and “RS-
232C” is selected, the password input box
will be displayed.
• Make sure that both the projector and
computer are set for the same baud rate.
Refer to the computer’s operation manual
for instructions for setting the computer’s
baud rate.
-72
Locking the Operation Buttons on the Projector
To Next Page
Loading...
Need help?
General
