STANDBY button
STANDBY
button
Air filter (not removable)
• This projector is equipped with air fil-
ters to ensure the optimal operating
condition of the projector.
• The air filters should be cleaned ev-
ery 100 hours of use. Clean the filters
more often when the projector is used
in a dusty or smoky location.
• Ask your nearest Sharp Authorized
Projector Dealer or Service Center to
exchange the filter (PFILDA005WJZZ)
when it is no longer possible to clean.
Cleaning and replacing
the bottom air filter
1 Press
STANDBY
on the projector
or
on the remote control to
put the projector into the
standby mode.
• Wait until the cooling fan stops.
2 Disconnect the power cord.
• Unplug the power cord from the AC
socket.
3 Remove the bottom filter cover.
• Turn over the projector. Grab the tab
and slide open the filter cover in the
direction of the arrow.
4 Remove the air filter.
• Pick the air filter up with your fingers
and lift it out of the filter cover.
AC socket
Tab
To Next Page
Loading...
Need help?
General
