04/1/28 XL-DH320N 350H_09 EN.fm
E-7
Listening to the iPod (continued)
Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.
Note:
When navigating the iPod menus with remote control, do
not operate any of the buttons on the iPod unit. The volume
level is adjusted by pressing the VOL (+ or –) button on the
main unit or the remote control. Adjusting the volume on
the iPod unit gives no effect.
iPod operation:
The operations described below depend on the generation
iPod you are using.
System on operation:
When the main unit is powered on, the iPod unit will
automatically power on when docked in the unit (including
TIMER function/exclude USB function).
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked
iPod unit will automatically turn to stand-by mode.
■ To insert iPod adaptor
1
Open the iPod cover by pulling up the tip.
2 Insert the iPod adaptor into the iPod dock and connect
your iPod.
■ To remove iPod adaptor
Insert the tip of a screwdriver (“–” type, small) into the iPod
adaptor hole as shown and lift upward to remove.
iPod
Dock connector
iPod (bottom)
iPod dock
iPod
connector
iPod adaptor
■ iPod playback
1
Press the ON/STAND-BY button to turn the power on.
2 Press the iPod button on the remote control or
FUNCTION button repeatedly on the main unit to
select iPod function.
3 Insert iPod unit in iPod dock of main unit.
4 Press the / button to start playback.
■ To disconnect iPod
■ Navigating the iPod menus
1
Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.
2 Use the TUNING ( or ) button to select an item on
the menu and then press ENTER button.
CD
USB
pull up
To Next Page
Loading...
Need help?
General
