Sharp XL-MP9H - Listening to the Memorised Station

05/5/23 XL-MP9H(H)E2.fm
E-19
ENGLISH
TINSZA058SJZZ
XL-MP9H
Radio
Listening to the memorised station
" Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Notes:
!
On the remote control, press the SHIFT button and then the
MEMORY button in step 2 and 4.
!
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead dis-
connection.
" To recall a memorised station
Move the operation lever toward PRESET or PRESET for less
than 0.5 seconds to select the desired station.
To select a preset station with the direct number buttons:
Press the corresponding number ("0" - "+10").
Example:
To select 28, press "+10", "+10" and "8".
" To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
" To clear a memorised station
" To erase entire preset memory
1
Perform steps 1 - 3 in "Listening to the radio" on page 18.
2
Press the MEMORY/SET button to
enter the preset tuning saving
mode.
3
Within 5 seconds, move the opera-
tion lever toward PRESET or
PRESET to select the preset
channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 5 seconds, press the MEM-
ORY/SET button to store that sta-
tion in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
1 Move the operation lever toward PRESET or PRESET for
more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Move the operation lever toward PRESET or PRESET again
when the desired station is located.
1 Recall the memorised station.
2 Whilst it is displayed, press the MEMORY/SET button.
!
On the remote control, press the SHIFT button and then the
MEMORY button.
3 Within 5 seconds, press the CLEAR button.
!
On the remote control, press the SHIFT button and then the
CLEAR button.
1 Press the ON/STAND-BY button to enter the power stand-by
mode.
2 Whilst pressing down the MEMORY/SET button and move the
operation lever toward PRESET , press the ON/STAND-BY
button until "TUCL" appears.