Sharp YB-S4202AE - Page 16

EN-15
COUNTER RESET
Each number of times can be cleared.
Example : Suppose you want to clear the times of memory 1.
Step Action Press key Display
1 Choose checking mode.
× 2
CHECK
CHECK will flash on and off.
(Total count)
2 Choose the memory 1.
CHECK
NUMBER
(Times memory 1 used)
3 Clear times of using the memory 1.
1
CHECK
4 Cancel checking mode.
NOTE:
1.
To clear times of manual cooking, touch MANUAL/REPEAT key ( ) at step 2 instead of NUMBER key.
To clear times of Defrost cooking, touch EXPRESS DEFROST key ( ) at step 2 instead of NUMBER key .
2. To clear total using times, skip step 2.
INFORMATION WITH ERROR MESSAGES
If ERROR messages are displayed, follow the below instructions.
ERROR MESSAGES
EE1, EE2, EE3,
EE6, E10, EE16,
EE19
Please contact your dealer or an authorized Sharp service agent because the
oven must be out of order.
EE7
Exhaust air temperature is too high. Checking that nothing is blocking the ventilation
openings or that room temperature is very hot or that oven cavity is empty during
operation. Correct, touch STOP/CLEAR key ( ) and try again after a few minutes .
EE9 The time you set exceeds a maximum time. Touch STOP/CLEAR key ( )
and enter appropriate time.
EE17 Magnetron temperature is too high, touch STOP/CLEAR key (
) and try
again after a few minutes.
INFORMATION WITH FILTER INDICATOR
Clean the air intake filter when the FILTER indicator lights up (See page EN-17). The FILTER indicator will light
up when the oven has been operated for about 200 hours in total.
To cancel FILTER indicator touch the START key ( ). The oven will start to count the operation time
automatically again when the FILTER indicator is canceled.