EN-6
INSTALLATION INSTRUCTIONS
NOTE
1. If you are unsure how to connect your oven,
please consult an authorized qualified electrician.
2. Neither the manufacture nor the dealer can
accept any liability for damage to the oven or
personal injury resulting from failure to observe
the correct electrical connection procedure.
3. Water vapour or drops may occasionally form
on the oven walls or around the door seals and
sealing surfaces. This is a normal occurrence
and is not an indication of microwave leakage or
a malfunction.
WARNING: Always keep the caution sheet (SPECIAL INSTRUCTIONS AND WARNINGS) close to the oven
for your reference.
1) Remove all packing materials from the inside of
the oven cavity. Remove all the blue protective
film from the outside of the oven.
2)
Check the oven carefully for any signs of damage
.
3) Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked.
Do not place this oven in a position which is not
easily
accessible. To position the oven too high can be
dangerous because food can not be removed safely
.
4) Ensure there is a minimum free space above the
oven of 25 cm.
5) Securely connect the plug of the oven to a
standard earthed (grounded) household electrical
outlet.
6) Two same oven models can be installed together
by placing one on top of another. Follow these
instructions.
6-1) Place the oven A and position the oven B on top
of the oven A as shown in the figure A.
6-2) Remove the single screw (a) holding the
mounting plate A to the rear cabinet of the oven
A. And remove the mounting plate A.
6-3) Remove the single screw (b) from the rear
cabinet of the oven B, as shown in the figure A.
6-4) Reinstall the mounting plate A to the rear
cabinet of the oven B with the single screw (b)
removed, as shown in the figure A.
6-5) Hold the mounting plate A to the rear cabinet of
the oven A with the single screw (a), as shown
in the figure A.
6-6)
Remove the screw (a) holding the mounting plate
B to the rear cabinet of the oven B. And remove
the mounting plate B from the oven B. See the
figure A.
6-7)
Install the screw (a) to its position again.
6-8)
Remove the screw (c) from the oven A.
6-9)
Remove the screw (d) from the oven B.
6-10)
Turn the removed mounting plate B over and
then using the removed screw (c) and (d), attach
the mounting plate B, as shown in the figure A.
WARNING:
In case where two ovens are installed together by
placing one on top of another,
1)
Use the two mounting plates for fixing the two
ovens.
2)
Make sure that the power supply cord is not caught
between the two ovens.
3)
Do not install more than one oven on top of another.
4)
Do not lose the removed screws.
Figure A: How to fix two ovens
Screw (a)
Oven A
Mounting plate A
Screw (b)
Screw (a)
Oven B
Rear cabinet
Mounting plate B
Reat Cabinet
Screw (c)
Screw (d)
4. Do not place anything on the outer cabinet during
operation.
5. Do not use the oven near a steamer or a fryer.
To Next Page
Loading...
