Entering characters
Keys and their functions
Moves the cursor to the right. (When an entry is
displayed, pressing this key will allow you to enter the
edit mode.)
Moves the cursor to the left.
Moves the cursor up a line.
Moves the cursor down a line.
Puts the Organizer into the insert mode. Pressing
(INS]
again returns the Organizer to the overwrite mode.
Deletes the character at the cursor position.
Backspace key. Deletes the character to the left of the
cursor.
Moves the cursor to the beginning of the next line (new
line).
Clears the data being entered.
Stores the data being displayed.
(If you wish to save an edited entry without deleting the
original entry,, press
(2ndJ
(GF&)
IMPORTANT: Individual capital letters may be entered by
pressing the desired key while “CAPS” is displayed.
Entering non-English characters
Entering “A”,
“D”,
“e”
and
“8”,
for example.
1. Press
(MEMO]
to enter the MEMO mode and press
B.
2. Press (CAPS]; “CAPS” displayed.
3.
Press
(2ndl
[
A.
4. Press (CAPS)
(2nd]
(7]
u.
5. Press
[2ndl
m
e.
6.
Press
[FZ
(71
o.
Note:
“c”
is entered by pressing (2nd)
[F].
Non-English
characters can also be entered as symbols.
Entering numbers
Use
101
through
(9)
to enter numbers.
Entering graphic symbols and special characters
Press
(SMBLJ
to enter the symbol entry mode. There are a total
of 33 symbols. In each display, five symbols are shown; to
change to a different display, press
a
or
a.
Select a
symbol by pressing its corresponding number.
To exit the symbol entry mode, press
(SMBLI
again.
5
To Next Page
Loading...
Need help?
General
