Name: Shelly PRO 1
Brand: Shelly
Rating: 5 (1 reviews)

To Next Page

To Previous Page

• Ethernet: Enable or disable Ethernet (LAN) connection. Changing this setting will

reboot the device.

• MQTT: Conﬁgure the Shelly device to communicate over MQTT.

• Cloud: Enables or disables the connection to Shelly Cloud. Connection to Shelly

Cloud allows you to control your device remotely and receive notiﬁcations and

updates.

Application Settings:

• PIN lock: Restrict control of the Shelly device through the web interface by setting

a PIN code. After typing the details in the respective ﬁelds, press “Restrict Shelly”.

• Sync name: Keep the device name in sync with the name given in the app.

• Input state Display: Turn on indicator for the current status of the physical switch

connected to Shelly Pro 1. When enabled, a small line appears under the power

button icon. A red line indicates the physical switch is off, while a green line indicates

the physical switch is on.

• Exclude from Event Log: Do not show events from this device in the app.

• Share: Share the control of your device with other Shelly Cloud users.

Settings:

• Input/Output Settings: These settings deﬁne the way the attached switch or button

controls the output state. The possible input modes are “button” and “switch”.

• Invert switch: If enabled, the device will consider the switch is on, while it is

actually switched off and vice versa.

• Device Name: Set a name for your device.

• Firmware version: Shows your current ﬁrmware version. If a newer version is

available, you can update your Shelly device by clicking Update.

• Geo Location And Time Zone: Set your timezone and geo-location manually, or

enable/disable automatic detection.

• Device Reboot: Reboot your Shelly Pro 1.

• Factory Reset: Remove Shelly Pro 1 from your account and return it to its factory

settings. This will delete all set data.

• Device Information: Here you can view the ID, IP and other settings of your device.

Upon clicking “Edit device”, you can change the room, name or image of the device.

THE EMBEDDED WEB INTERFACE

If your Shelly Pro 1 is in AP (Access Point) mode, connect your PC or mobile device

to the Wi-Fi network with the name (SSID) such as ShellyPro1-f008d1d8bd68. Enter

http://192.168.33.1 into the address ﬁeld of your browser to load the web interface

Questions and Answers:

Need help?

Do you have a question about the Shelly PRO 1 and is the answer not in the manual?

Shelly PRO 1 Specifications

General