EasyManuals Logo

SHERCO ST 125 User Manual

SHERCO ST 125
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
8
ST SERIES
CYCLE PARTS
❱❘ FRONT
1.1 Replacement of wheel bearings
Loosen the locking screw located on the
right tube.
Loosen the axle, using a BTR key and
remove it.
Take out the wheel.
Front wheel axle tightening : 100Nm
Use a heat gun to heat the bearing
surface on the hub
.
Remove the bearings using a flush
valve and then replace them with new
ones, reference 0175.
1.2 Front disc replacement
When replacing the front brake disc,
apply when reassembling the Loctite
243 and on the screws and tighten to a
torque of
12Nm
Proceed in the reverse process and
lightly grease the front axle.
WARNING
Before any operation, make sure that the motorcycle is properly fixed
and that it cannot fall
WARNING
Using a caliper, check the size of the internal spacer reference 5930 on the front wheel
and replace it if necessary.
Minimum tolerance
:
67.5mm

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SHERCO ST 125 and is the answer not in the manual?

SHERCO ST 125 Specifications

General IconGeneral
BrandSHERCO
ModelST 125
CategoryMotorcycle
LanguageEnglish

Related product manuals