Need help?Do you have a question about the SHERCO 300 SEF FACTORY and is the answer not in the manual?
General| Displacement | 303.68 cc |
|---|---|
| Compression Ratio | 12.5:1 |
| Cooling System | Liquid-cooled |
| Fuel System | Electronic Fuel Injection |
| Starting | Electric starter |
| Transmission | 6-speed |
| Front Tire | 90/90-21 |
| Rear Tire | 140/80-18 |
| Seat Height | 950 mm |
| Ground Clearance | 355 mm |
| Bore x Stroke | 84 mm x 54.8 mm |
| Clutch | Wet multi-disc |
| Front Brake | 260 mm disc |
| Rear Brake | 220 mm disc |
| Fuel Tank Capacity | 9.7 liters |
| Engine Type | 4-stroke, single-cylinder, DOHC |
| Frame | Chrome-molybdenum steel semi-perimeter |
Procedure to remove the engine from the motorcycle chassis.
Procedure to reinstall the engine into the motorcycle chassis.
Steps to remove the cylinder head from the engine.
Procedure for setting the engine valve timing correctly.
How to check and adjust engine valve clearance.
Procedure to disassemble the transmission and crankshaft.
Checking crankshaft radial play, lateral movement, and run out.
Steps for installing crankshaft, transmission gears, and shafts.
Specifies torque values for various engine components.
Specifies torque values for motorcycle frame components.
Wiring diagram for the main wire harness of the motorcycle.
Overview of the Synerject injection system components.
Description of the Exxodiag diagnostic tool and its kit contents.
Guide for installing the diagnostic software and drivers.
Continuation of the diagnostic tool software and driver installation process.
Final steps for installing the diagnostic tool software.
Connecting the diagnostic tool to the computer and motorcycle.
Steps for connecting the diagnostic tool with the keyless system.
To Next Page
