Need help?Do you have a question about the SHERCO 2015 450 SEF-R and is the answer not in the manual?
General| Year | 2015 |
|---|---|
| Manufacturer | SHERCO |
| Model | 450 SEF-R |
| Category | Enduro |
| Compression Ratio | 12.5:1 |
| Transmission | 6-speed |
| Final Drive | Chain |
| Front Brake | Single disc |
| Rear Brake | Single disc |
| Front Tire | 90/90-21 |
| Rear Tire | 140/80-18 |
| Engine Type | Single cylinder, 4-stroke |
| Bore x Stroke | 95.0 mm x 63.4 mm |
| Cooling System | Liquid-cooled |
| Fuel System | Fuel injection |
| Ignition | Electronic |
| Front Suspension | 48 mm |
| Rear Suspension | Monoshock |
| Seat Height | 950 mm |
| Ground Clearance | 355 mm |
| Displacement | 449.40 ccm (27.42 cubic inches) |
Manual intended for qualified mechanics working in a properly equipped workshop.
Details engine type, displacement, bore, stroke, compression, fuel, and lubrication.
Details frame, fork, suspension, brakes, tires, steering angle, and weight.
Original settings for compression, rebound, spring stiffness, and oil type/level for the fork.
Factory settings for low/high speed compression, rebound, and spring stiffness.
Step-by-step guide for safely removing the engine from the motorcycle frame.
Step-by-step guide for installing the engine back into the motorcycle frame.
Initial preparation steps for engine disassembly, including draining oil and removing covers.
Instructions for removing the cylinder head, cylinder, and piston.
Checking crankcases and bearings for damage or wear.
Measuring radial/lateral clearance and checking crankshaft runout for wear.
Measuring cylinder wear and piston/ring clearances for proper fit.
Steps for assembling the engine's central crankcases, including shafts and gears.
Correctly positioning and installing the piston rings, piston, cylinder, and head.
Lists required equipment and steps for removing the throttle body from the motorcycle.
Procedures for cleaning the throttle body and its associated electrical connectors.
Overview of the Synerject injection system and its main components like ECU and sensors.
Guide to the diagnostic software, its menus, configuration options, and updates.
Procedures for checking stator resistance and engine speed sensor values.
Details alternator output voltages and currents at different RPMs and tolerances.
List of connectors and their functions in the injection wiring harness for the motorcycle.
Diagrams and color codes for light and accessory wiring harnesses.
To Next Page
