37
ENGLISH
❱❘ Completing the engine assembly
• Clean the sealing surface of the cylinder head
cover.
• Apply silicone sealant on both semi-circles.
• Fit the cylinder head cover gasket and cylinder
head cover.
• Screw the cylinder head cover along with the
O-rings of the 3 screws.
Tightening torque for screws cylinder head
cover: 10 Nm.
• Applying copper grease on the threads of the
spark plug.
Tightening torque of the spark plug: 16 Nm.
• Put in the TDC plug, tighten it to 15 Nm.
❱❘ Installing the ignition cover
• Set the guide pins.
• Fit the ignition cover gasket.
• Apply silicone dough on the wire guide.
• Put the 4 screws of the clutch housing.
Torque setting: 10 Nm.
• On the secondary shaft, put the O-ring, the
spacer, the pinion, and the washer.
• Apply red thread lock on the nut.
tighten to 100 Nm.
ENGINE ASSEMBLY
To Next Page
Loading...
Need help?
General
