Section 8 Handling of mower
43
(2) Position when lapping
● Lower the reel on a flat and stable ground.
● Pull out the L-shaped pin from the rolling arm.
● Turn the front roller of the reel unit to the
front.
(3) Position when adjusting the cutting height
● Determine the position in the same way as in
lapping.
● Hold the both edges of the front roller and
turn the roller upward.
● To return to the original position, start the
engine and move the lifting/lowering lever to
the lifting side. When the reel unit lifted above
the ground, move the lifting/lowering lever to
the lowering side. Then the mowers return to
the position of lapping.
To Next Page
Loading...
