4. Other instructions
fault, injury or electric shock, etc.
Delivery the products correctly according to their weights.
It is not allowed to stack the products in excess of the specified layers.
Do not carry the motor by the cables, shaft or encoder.
Do not hold the front cover to transport the drive. Otherwise, it may be dropped.
The servo drive and motor must be installed in the specified direction.
Inside control box, preserve enough space between the servo drive and other equipment.
Provide adequate protection to prevent screws and other conductive matter, oil and other
combustible matter from entering the servo drive.
Do not drop or strike servo drive or servo motor. Keep from all impact loads.
Use the servo drive and servo motor under the specified environmental conditions.
Firmly attach the servo motor. Otherwise, it may come off during operation.
For safety of personnel, always cover the rotating and moving parts.
Never impact the servo motor or shaft, especially when coupling the servo motor to the
machine. The encoder may become faulty.
Do not subject the servo motor shaft to more than the permissible load. Otherwise, the
shaft may be broken.
When the equipment has been stored for an long period time, consult Shihlin.
In order to prevent from fire or other accidents, please use the cable specified in this user
manual to wire the servo equipment.
Wire the servo drive correctly and firmly. Otherwise, the motor will run improperly.
Do not install a power capacitor, surge absorber or noise filter between the servo motor
and servo drive.
Do not connect AC power directly to the servo motor. Otherwise, it results in damage of
servo motor.
The surge absorbing diode installed on the DC output signal relay must be wired in the
specified direction. Otherwise, the emergency stop and other protective circuits may not
operate.
To Next Page
Loading...
Need help?
General
