Shimano Steps DU-E6002 - Page 30

https://shimano-steps.com/
56 57
https://shimano-steps.com/
E8000 Series
E6000 MANUALE8000 CONCEPT E8000 MANUAL E6000 CONCEPT
CONNECTING THE ELECTRIC WIRE
Set so that the projection on the connector is aligned with the
groove in the narrow end.
(A)
TL-EW02
(B)
Plug
(A)(B)
(A)
TL-EW02
(B)
Plug
Use the Shimano original tool for installation
and removal of the electric wire.
When installing the electric wire, do not forcibly
bend the plug.
It may result in a poor contact.
When connecting the electric wire, push it in
until it clicks in place.
Connect the electric wire to the assist switch
1. Remove the cable cap from the assist switch.
(A)
Cable cap
(A)
2. Pass the electric wire through the cable cap, and connect it to
the assist switch.
(A)
Cable cap
(B)
Electric wire
Make sure the electric wire is connected through the cable cap. If the wire is
not passed through the cable cap, the electric wire connector may be damaged.
(A)(B)
NAME OF PARTS
(D)
(I)
(J)
(M)
(A)
(B)
(L)
(C)
(E)
(N)
(H)
(F)
(G)
(K)
(P)
(O)
(A) Cycle computer:
SC-E8000
(B) Assist switch:
SW-E8000-L
(C) Front chainring:
SM-CRE80/SM-CRE80-B
(D) Chain device:
SM-CDE80
(E) Crank arm:
FC-E8000/FC-E8050
(F) Drive unit:
DU-E8000
(G) Speed sensor:
SM-DUE10
(H) Drive unit cover:
SM-DUE80-A
(type that covers drive unit
ports)
SM-DUE80-B
(type that covers drive unit
ports and the frame
installation bolts)
(I) Battery (external type)/
Battery mount (external type):
BT-E8010/BM-E8010
(J) Battery charger:
EC-E6000
(K) Battery (built-in type)/
Battery mount (built-in type):
BT-E8020/BM-E8020
(L) E-TUBE (EW-SD50)
When using electronic gear shifting
(M) Shifting switch:
SW-M9050-R
SW-M8050-R
(N) Rear derailleur (DI2):
RD-M9050
RD-M8050
(O) Speed sensor:
SM-DUE11
(P) Disc brake rotor:
RT-EM800
RT-EM900
Maximum cable length (EW-SD50)
(L)
≤ 1600mm