Shimano Steps DU-E6002 - Page 71

https://shimano-steps.com/
138 139
https://shimano-steps.com/
E6000 Series
E6000 MANUALE8000 CONCEPT E8000 MANUAL E6000 CONCEPT
CHARGING THE BATTERY
Refer to ” CHARGING THE BATTERY ” (page 120).
Refer to ”
BATTERY HANDLING ” (page 35).
BASIC OPERATIONS
Refer to “ BASIC OPERATIONS ” (page 127).
In the Case of Internal Geared Hub Shifting
Wire harness
E-TUBE
• The drive specification may be of the belt type. In this case, the front chainring, rear sprocket and belt are supplied by the belt’s manufacturer.
Also, for details concerning assembly and adjustment, refer to the technical information provided by the belt manufacturer.
• For information on how to install MU-S705, refer to “Installation of the motor unit to the hub (MU-S705)” in the dealer’s manual for the ALFINE
S705 series.
SYSTEM SPECIFICATIONS
Operating temperature range:
During discharge
-10 – 50 °C Battery type Lithium Ion Battery
Operating temperature range:
During charging
0 – 40 °C Nominal capacity
14 Ah (504Wh)
11.6 Ah (418Wh)
Storage temperature -20 – 70 °C Rated voltage 36 V DC
Storage temperature (Battery) -20 – 60 °C Drive unit type Midship
Charging voltage 100 – 240 V AC Motor type Brush-less DC
Drive unit maximum torque 50 N·m Rated drive unit power 250W
Note: The range of the assist function speed is different depending on the specifications. DU-E6000, E6001, E6010: 25km/h or less.
Motor unit
MU-S705
Assist switch
SW-E6000
SW-E6010
Internal geared hub
SG-C6061
SG-S7051-11
SG-S7051-8
Cycle computer
SC-E6010
SC-E6000
Shift switch
SW-E6000
SW-E6010
Electric wire
EW-SD50
Maximum
cable length
≤1600 mm
Electric wire
EW-SD50
Maximum
cable length
≤1600 mm