https://shimano-steps.com/
166 167
https://shimano-steps.com/
E6000 MANUALE8000 CONCEPT E8000 MANUAL E6000 CONCEPT
6. Fully tighten the key unit cover fixing bolts (M4) to
attach the key unit cover.
Tightening torque:
0.6 N·m
7. Mount the battery rattle prevention spacer.
8.
Peel the release liner off the double-sided seal on the
back of the battery rattle prevention spacer and mount.
9. Insert the plug into the mount lower case. Insert the
plug between the mount upper case, and secure them
using the mount upper case fixing bolts (M3).
Tightening torque:
0.6 N·m
Check that there is no oil, foreign objects, etc., on the adhesive surface
of the double-sided seal or on the surface to which the double-sided
seal is to be attached. If there is, remove it.
Mount
upper case
Plug
Key unit cover
fixing bolt
(M4)
Key unit
cover
Battery rattle
prevention spacer
Double-sided seal
Mount upper case
fixing bolt (M3)
For Down Tube Mounting
<SM-BME61>
1. Attach the mount lower case to the mounting holes in
the frame, insert the mount fixing bolts (M5) into the
washers, and secure the case using the bolts.
With the 3 mm Allen key
Tightening torque:
3 N·m
2. Temporarily attach the key unit with the key unit
fixing bolts (M5).
Key unit is not included with Shimano products.
Key unit fixing bolt (M5)
Washers
Key unit (not
included with
the product)
Mount lower case
Mount fixing bolt
(M5)
3. Adjust the position of the key unit to allow a
clearance of 223 mm between (a) and (b) shown in the
illustration.
4.
Temporarily attach the key unit cover and perform
adjustment to make sure that the battery can be
smoothly connected and disconnected and no noise
will be produced due to looseness during traveling.
5.
Fully tighten the key unit fixing bolts.
With the 3 mm Allen key
Tightening torque:
3 N·m
223 mm
(a)
(b)
To Next Page
Loading...
