56
MAINTENANCE
Replacing the brake hose
3. Install the brake hose in the caliper.
Insert the hose up to the witness mark added beforehand on the surface of the hose is
covered.
Connecting bolt
NOTICE
• Do not let the brake hose become twisted when installing it. When the caliper
and brake lever are not installed on the bicycle, there is no twist in the hose if
the caliper and brake lever are in the positions shown in the figure below.
4. Tighten the connecting bolt while pushing on the brake hose.
Connecting bolt
5 - 7 N·m
To Next Page
Loading...
