20
ADJUSTMENT
Installing the inner cable and adjusting gear shifting
2. Adjust the cable tension.
Adjust the cable tension with the cable adjustment barrel or cable adjuster on the frame,
so that the indicator lines of the bracket and input link are aligned.
If the cable was given too much tension and the bolt was loosened, be sure to release it
first in the lowest position. Then, check the indicator position once again at the T-trim
position.
Once the cable tension has been adjusted, install the chain.
Bracket line (indicator)
Cable adjustment barrel
Input link line (indicator)
Top adjustment
1. Align with the gear where the lever is released from the top position
to the T-trim position.
L-trim
T-trim
Low
Top adjustment point
Top
To Next Page
Loading...
